-40%
Ensys Moxon 868MHz Directional Antenna (Flexible Lead)
$ 8.97
- Description
- Size Guide
Description
A 3D Printed Frame Moxon Antenna With SMA connector.Moxon directional antenna made with 3D printed frame and fiberglass tube. It is quite sturdy and rigid.
The Moxon is a directional antenna system that is gaining in popularity because it offers three very distinct advantages over a typical two element Yagi:
Small in physical size
. The Moxon can be built using a very lightweight structure and wire elements, which will fit into a footprint about two thirds the area required for a conventional beam. You can see by the measurements above that a 20 meter Moxon is only 25 by 9 feet. Being a very light structure, typically made from wire and lightweight spreaders, it can easily be mast mounted on a lightweight pole, hoisted up in a tree from an overhanging branch, or turned vertically and ground mounted! As such it also makes an excellent field antenna.
Outstanding front to back ratio.
The Moxon’s front-to-back ratio models at greater than 30dB! Moreover, close-gap coupling enables the Moxon’s enhanced performance to be realized at lower elevation heights of only 1/2 wavelength. As seen below, the Moxon exhibits a broad forward area combined with superior front to back.
The Moxon is a
50 ohm antenna
,
generating a near perfect 1:1 swr without requiring any additional matching devices. It is also quite broadbanded allowing for effective full band coverage.
Width
– 8 mm.
Weight
– 0,05 kg.
Tube material
– Carbon Fiber
Connector
– Male SMA
Material
– 3D printed plastic
Impedance
– 50 Ohm